CA-PSU 200-240V

New product

Power supply for A500/600/1200 with cable drop compensation technology.

More details

This product is no longer in stock

By buying this product you can collect up to 39 loyalty points. Your cart will total 39 loyalty points that can be converted into a voucher of $0.95.


$97.20

Add to wishlist

More info

CA-PSU stands for "Compact Amiga Power Supply Unit", where "compact" designates the three target computers A500, A600 and A1200. It is the first power supply on the market that fully complies with the original Commodore specifications, introducing cable drop compensation for best regulation that even settles the voltage drop in the input filter of the target computers. This means that the voltage on the main 5V rail will never deviate more then 0.9%, measured inside the computer - no matter if the computer is in vanilla configuration or heavily expanded. Conventional power supplies will either supply too-high voltage to a vanilla machine, or too-low voltage to an expanded machine, causing malfunction or even defects. This cannot happen with  cable drop compensation technology.

Technical data in short:

5V, 5A, ripple/noise 50mV max. (typically 30mV)
Overload on 5V tolerated up to 8A for 30 seconds
5V load regulation <0.6% typical, max. 0.9% under overload condition
12V up to 4A
-12V, 0.1A
modern, high-efficiency DC-DC converter technology
total output power up to 50W
fanless, silent, extremely low heat
CA-PSU is a two-brick solution: One mains-connected power brick and the CA-PSU converter box with the switch and square 5-pin DIN connector to the computer. This moves the power switch a lot closer to the computer, reducing the probability of inadvertent switching, for example if the power supply is under the table near your feet.

CA-PSU has the best overall efficiency on the market, with a worst-case efficiency of 77% (best case >82.5%). The best competing product peaks at just over 70%, and some original Commodore power supplies have an efficiency of less than 55%. This means that there's less total heat, less power consumption and a longer life expectancy because there is less stress on the components.

Naturally, CA-PSU features over-voltage protection - every modern power supply does. We wouldn't consider it worth mentioning, but this protection is part of a more complex block to protect your valuable classic gear: There are two critical moments that need to be taken care of: Switching on and off. CA-PSU has a controlled 5V ramp-up when switching on, ensuring safe power-up of heavily-expanded machines. Traditional power supplies without such a controlled startup-ramp tend to "swing in" to the target voltage, which might cause malfunction (a reset after power cycle may be required) or even defects. Further, switching off will start a short timer, ensuring that the next switch-on event can't happen until about 6 seconds after switching off. This ensures that capacitors in the computer and expansion gear are sufficiently discharged, and switching on won't cause 3.3V regulators of modern expansions to oscillate, which may cause severe damage.

In the unlikely event that these elaborate precautions fail, CA-PSU is covered by a German product liability insurance.

Length of the 230V cable: 100cm from connector to connector.

Length between power brick and DC-DC converter box: 75cm min.

Length between DC-DC converter and Computer: 30cm min.

Reviews

No customer reviews for the moment.

Write a review

CA-PSU 200-240V

CA-PSU 200-240V

Power supply for A500/600/1200 with cable drop compensation technology.

7 other products in the same category:

Cart 0 Product Products (empty)    

No products

To be determined Shipping
$0.00 Tax
$0.00 Total

Prices are tax included

Check out

Product successfully added to your shopping cart
Quantity
Total
There are 0 items in your cart. There is 1 item in your cart.
Total products (tax incl.)
Total shipping (tax incl.) To be determined
Tax $0.00
Total (tax incl.)
Continue shopping Proceed to checkout

PayPal