Micromys V4

Requirements:

Any Amiga, C = 64/128, Atari ST / STe / Falcon.

Product Features:

Micromys V4 is an adapter for connecting standard mouse PS / 2 to your Amiga, C = 64/128, Atari ST. The only so-rounder device in retro computer market.

The new version of the adapter is designed to get rid of the dip switches, used for configuration. At this time, the device adjusts to most computers automatically (though, in some cases it is necessary to press the mouse button).

Here are the available modes adapter:

Amiga wheel mode:
    Just plug in the device and turn on the computer. Micromys V4 will detect that it is plugged into the Amiga and switches to work two-button mouse with scroll wheel. Wheel and middle button can be activated by the driver available on the www.micromys.de

Amiga Mode 3 buttons without driver:
    The user presses and holds the third button or wheel when turning on the Amiga. Mode remains active until you turn off the Amiga. Reset Amiga does not exclude this mode, only the power cut.

Atari ST / STe / Falcon:
    Just plug in and turn on the power. The device automatically detects that it is connected to the Atari and switch mode wodpowiedni .. Atari mode supports two buttons, the rest are ignored. The following models have not been tested with the adapter, but it should work fine: Atari Stacy, Atari TT 030, C-LAB Falco, ATW.

Mode C = 64/128 on the joystick port 1:
    It is normal for the mouse port 1351. Most programs use it to operate the mouse, as the GEOS operating system, I expect that the mouse is plugged into it. If the adapter is plugged into it, the computer will detect and switch to mouse mode 1351. During startup, the user must hold down the right mouse button to move the joystick emulation mode, as in the case of the original mouse 1351.

Mode C = 64/128 on the joystick port 2:
    This port is hardly used for the mouse. However, quite a popular music program Prophet64 MSSIAH and use the mouse in that port. If you want to use port 2, you must connect the adapter when the computer starts and when you start the program. Previously, the program must be set to use the mouse. As the auto detection in port 2 is highly dependent on software (therefore does not always work), Micromys V4 can only be set in mode C = 64, by removing the jumper from the auto detection inside the adapter. From that moment on auto-detection is disabled and bypasses the adapter auto-detection, and only works in C = 64, no matter in which port is plugged. This configuration also allows you to use the adapter joystick emulation mode on other computers than C = 64

In order to fit into the limited space on a desk, Micromys V4 is provided with a long cable. This allows for installation in every corner of the desk, even with an adapter USB-PS / 2

Due to the small amount of space at the port of the Amiga 600 mouse and joystick port No. 1 in C = 128, is required to connect an adapter to the smaller plug or a modification of the original plug adapter.

Package Contents:

Adapter Micromys V4

Warranty 2 years